Common Causes of Motor Winding Failures
Lange Electric
 |
|
 |
|
Phone: |
Motor Rewinding
The life of a three-phase stator winding can be
shortened dramatically when the motor is exposed to
unfavorable operating conditions - electrical,
mechanical or environmental. The winding failures
illustrated below are typical of what can happen in
such circumstances. They are shown here to help in
identifying the causes of failure so that, whenever
possible, preventive measures may be taken. A new
stator winding is pictured at right for purposes of
comparison. Descriptions of the causes of failure.
are provided below.
|
|
1 & 2 - A single-phased winding failure is the result of an open in one phase of the power supply to the motor. The open is usually caused by a blown fuse, an open contractor, a broken power line or bad connections.3 - 8 - These photos illustrate insulation failures that typically are caused by contaminants, abrasion, vibration or voltage surge.9 - Thermal deterioration of insulation in one phase of the stator winding can result from unequal voltage between phases. Unequal voltages usually are caused by unbalanced loads on the power source, a poor connection at the motor terminal, or a high-resistance contact (weak spring). NOTE: A one-percent voltage unbalance may result in a six- to ten-percent current unbalance.10 - Thermal deterioration of the insulation in all phases of the stator winding typically is caused by load demands exceeding the rating of the motor. NOTE: Under-voltage and over-voltage (exceeding NEMA standards) will result in the same type of insulation deterioration.11 - Sever thermal deterioration of the insulation in all phases of the motor normally is caused by very high currents in the stator winding due to a locked rotor condition. It may also occur as a result of excessive starts or reversals.12 - Insulation failures like this usually are caused by voltage surges. voltage surges are often the result of switching power circuits, lighting, strikes, capacitor discharges and solid-state power devices.Source: Electrical Apparatus Service Association, Inc. (EASA)
|